[mmzcee]

Hello all,

I'm selling this set of VMR VB3 18x9.5 ET22 square setup. 74.1mm CB.

As pictured on the car, 275/35/18 all around w/ 3mm spacer up front. //M stickers included but no center caps (reuse your originals). Spacers not included. You can also run 245/40/18 or 255/35/18 up front (no need for spacer)..

Tires not included (unless local, two rear tires still has 40% tread left).

Asking $750 shipped for the set OBO within CONUS.

In excellent condition, no curb rash. Only a few nicks on one of the wheels less than a few mm small.

Local pickup welcome w/ cash ($650.00).

Paypal only. Please email inquires to [email protected].

Thanks for looking!

 

[mmzcee]

Will throw in this set of BMW center caps for free.

http://www.m5board.com/vbulletin/pa...966-fs-four-68mm-black-white-center-caps.html

 

[TQ2K]

Wheel weight?

 

[mmzcee]

Wheel weight?

Approximately 24-25 lbs per wheel.

Sale pending.

 

[mmzcee]

SOLD

 

[fahrven]

anyone know how these wheels stand up to track driving? i love the look but just afraid that i'll crack them

 

[mmzcee]

anyone know how these wheels stand up to track driving? i love the look but just afraid that i'll crack them

VMR wheels are gravity cast so that means they're a bit heavier in order to retain structural integrity. I've come across no cases of structural integrity being compromised on VMR's wheel line so I'm sure they'd be fine. However, for dedicated track use - you should look into APEX ARC-8s in 18x10. They are extremely light at around 19-20 lbs each whereas these VMR weigh a hefty 26-27lbs each.