BMW M5 Forum and M6 Forums banner

1 - 3 of 3 Posts

Registered
Joined
447 Posts
Discussion Starter #1
Im having an issue with my 95 CSI car not cranking whatsoever, i just recently changed the EML (the original units main board had been corroded and the car would run fine except that when "sport" button is pushed it ran rough). Now that i replaced the EML module the car doesnt start and im not sure why.
Any US Csi owners willing to test the DME and EML from my car on their car and see if it works, it literally is just plug and play with no programming involved.
 

Registered
Joined
534 Posts
If you change the Eml you have to get it coded back to the Dme.
 

Registered
Joined
5 Posts
If you send me the corroded one I can repair it for you. The DME has EWS on a 95 but I'm not aware the EML is involved. You can change the eprom from the corroded EML over to the new one and it will think its the same. The Auto and Manual EML share the same hardware, its only the software that determines which functions operate.
 
1 - 3 of 3 Posts
Top