Search Results for ‘dme’

Just installed Supersprint manifolds and sport cats on 01 e39 M5. Initially SES light came on and several fault codes were generated. After two test drives, the SES light has not returned, but two fault codes have: Catalytic converter conversion bank 1 and bank 2. The vehicle is essentially...

Hay i got K+DCAN cable i want to read full DME information for my M5 E60. Any software to read i already try MSSFlasher and BMWFlash but unable to read. Thanks

Hello M5Board members, I am in need of some assistance for some fault codes that I cannot seem to find any threads or discussions for. I have searched on Google and the forums and cannot find any clear answer to what the fault codes mean. I have the following codes: Codes from Rheingold >...

Reposting as the previous post didn't seem to go through. Hi M5Board! First time poster here. I recently got a '00 M5 and was messing around with the DME coding. Before I did anything I used BMWFlash and backed up both full and partial (512K and 32K, respectively) binaries. I modified my...

Hi M5Board. First time poster here. I recently got a '00 M5 and I was messing with the DME a little bit. I exported both full binary (512KB) and parameters binary (32KB) using BMWFlash. I modified the parameters binary and flashed it to my DME with BMWFlash. I turned key from 2 to 0, waited for...

Hi everyone! My beast has gone into Protection Mode twice over the past two weeks. After cycling the ignition the car starts up with no issue and runs like a champ. I pulled codes 158 and 163 which both read "Reset DME over speed". I have never seen those codes before and haven't found any...

I purchased a tune from jailbreak tuning through the group deal. I bought a Galletto 1260 cable from amazon. Using the software that jailbreak sent me I tried to read the ECU data but kept getting "Turn 10sec off and turn on the dashboard wait 10sec before continue" (see attached). I tried...

So, I have been having some vanos issues lately. You can find the thread "Vanos Solenoid!!!" and read the back half starting on page 4 of what has been going on. I pulled the DME after tracing the wires in the engine bay checking for any signs of tears, shorts, grounds, open circuits...

My car has about 150K miles on it and I've been battling a problem for almost 2 years. The car runs rough on a cold start and then runs better but is still a little "off"....the power has been the same. Because the car is so old I've replaced the mafs, all the O2 sensors, spark plugs, coils...

Ok.... Very frustrating Day at the dealership. My car a 2006 with 65k. I first want to say thank you to Eloy for setting the service guy right at Bill Jacobs in naperville. Here is what happened.. My car had a rough Idle, the slow rpm up and down, it started a week ago and came and went...

Hello M5 enthusiasts Does anybody know something in this topic / any experience. I want to take a look on my eeprom and base maps. I am interested in S38B38 Bosch DME. Let's start with few question 1. Is the WINOLS sufficient sw to tune this ECU? 2. Do I have to get some layout - on order...

Recently installed a Stage 2 Air Intake from AFE on my 2006 BMW M5. Immediately upon starting the car, two fault codes came up and my mechanic has been unable to troubleshoot. Codes are: 1) 2737/2738 - Filling, plausibility (Banks 1 and 2) 2) 2712/2713 - Air-Mass Sensor, plausibility. We...