I ran across my spacer that I had made while messing with the e39,the spacer is made from a sheet of aluminum 3/8 thick just a mili tick under 10mm. See pics in the "View my 01 M5" under the avitar.
With the spacer are 4 round spacers that go with for the center holes in the center, everything to space the plenum. All that is needed to install is remove stock studs and use longer 10mm bolts or better yet remove stack studs and install 10mm longer ones.
I never tested it and no one on the board back then stepped up to try it either, so any hp.???
$100.00
I'll be listing my 54mm throttle bodies very soon, I'm just missing one that I had left at a shop a while back, when I get my hands on it I'll list the t/b's.
later Keith kalbright@satx.rr.com
Exterior:
E6 CSL splitter & rear diffuser trim , E6 carbon hood ,E6 carbon eyelids
M motorsport door emblems
Tecknic carbon door pillars
Hamann Rear Diffuser
Interior:
UUC SSK , Euro dash conversion & center armrest,
Alcantara steering wheel & shift/e-brake boots, TEC cup holder
Misc.../In the works../Considering todo..:
[size=1]Rennsport/Tecknic v/stacks (uninstalled)
Plenum Spacer DONE! but not tested (4-5-04)
Extra set of stock t/boddies (bored to 54mm)
Last edited by Keith97M3turbo; 14th April 2008 at 02:24.
Front splitter is E6 Designs. Mark now owns the car ,I think he goes by eclipse, my old car is the on the Dinan S2 challenge, I wish I had been driveing it.
FastPOLACK, I did dyno it but with all the mods in my old sig, headers,race cats,pulleys,cams,differential,ect... see sig below.
On a Mustang Dyno (which are different than Dynojets)and some say put up lower numbers, the car made at the wheels 374hp and 328tq with afr's 13.1-13.6 across the rpm.
The new owner hasn't redynoed it yet with the dinan tboddies,I'm anxiously waiting for the new results with that last mod, if I remember right Mark's post name is Eclipse. Keith
Linear Mode
