I am trying too pin point an issue that i have been noticing for the past few hundred miles or so.
I have been getting vibrations and clutch slip between 2000-3000rpm. It can happen in any gear, most noticeable in 3rd, doesnt happen in 1st, or not that i have noticed.
It happens when i give it full throttle and will slip and rev.
Below 2000rpm, it holds up fine, and above 3000 rpm, it pulls really hard and no issues at all and right up to the red line.
I am running the dual mass CNS clutch and flywheel, it has about 10,000 miles on it.
I am wondering if the issue could be engine mounts or maybe tranny or diff mounts?
Or maybe clutch/drive train related?
The suspension has been fully rebuilt so im confident there isnt any issues here.
Any ideas guys?